200212H-2 Ring Helper Air Bags For Extract Juice From Fruits And Vegetables

200212H-2 Industrial Air Spring GUOMAT Air Bags with Ring For Extract Juice from Fruits and Vegetables​

Guomat 200212H-2 industrial swing air spring specifications

❶Nut/blind nut
Nut length: 25 mm
Number of screws on the top cover: 12
Number of bottom cover plate screws: 12
Top plate screw (nut) tooth: M10
Screw (nut) teeth of the bottom cover plate: M10
❷Air hole/air inlet/air fittings
Air hole/air inlet: G1 / 2
❸Cover plate
Top plate diameter: 350 mm
Diameter of the bottom cover: 350 mm
Bell rubber bellows
Opening of rubber bellows: 208 mm
Straight diameter of rubber bellows: 280 mm
Natural diameter of rubber bellows: 240 mm
Natural height of rubber bellows: 224 mm
Stroke: 90-250 mm
❺Bumper block/bumper block
No bumper block
❻Belt loop/Belt loop
No belt loops: three belt loops

Practical modern solutions:

An air spring is an inflatable rubber device that is responsible for carrying high loads and absorbing vibrations from industrial equipment, and can replace common steel springs or other hydraulic balancing systems. Compared with the methods commonly used today, this method is known for its high mechanical reliability.

The advantage of the air spring is that it can make noise from the vibration of industrial equipment.
When industrial equipment is working, vibration will generate a lot of noise. When the air spring is inflated, it absorbs the vibration of the industrial equipment and the industrial equipment is elevated. When the air is exhausted, the industrial equipment becomes more stable and the noise generated becomes lower.

In fact, by adding or removing air from the spring, the vehicle can bounce instantly in a short period of time. When adding weight to industrial equipment, air can be added to increase the pressure bearing capacity of the air spring.
The air spring system combines an air compressor and an air storage tank, which is responsible for providing air at the toggle of the switch to allow the spring to inflate and deflate.

The Composition Of Industrial Convoluted Air Spring Element Has The Following Aspects

❶Nut / Blind Nut – As well a permanent part of the Cover Plate assembly. Provides an alternative to bolt installation system. It is inside defect within the iron plate

❷ Gas Hole / Air inlet / Air Fitting – Most usually 1/4 N.P.T. which provides the air entrance to the rubber bellows.

❸ Cover Plate - Curled up to more durable bellows design and the largest quality control in the factory. Allows 100% of the leak test before shipment.

❹Rubber Bellows - Air Bellows includes four layers of materials: an inner layer, two layer cord - reinforced fabrics, and a cover. Construction of a natural rubber provides – 65F functional properties.

❺ Bumper block / Buffer block - Solid rubber or engineering plastic device designed to prevent major damage to the vehicle or suspension in the event of a sudden loss of air pressure in the spring.

❻ Girdle Hoop / Girdle Ring - Molded wire-wound ring to provide lateral stability of the complex type spring bellows.